Subpage of V3 basic flags

• The isTriggerError flag shows if any trigger error occured, for details use the Trigger error type flag.
• The Trigger error type flag shows which type of trigger error has been detected by the ECU.
• The error message will show the problem at least 1.6 seconds.
• If more then one error has been detected, the latest error message will be shown.
• Meaning of values:
  • No Tr Error: no trigger error detected.
  • Too many Pr.trig: too many primary triggers detected (secondary trigger can be missing).
  • Less Pr.trig: less primary trigger detected than it should be.
  • Too many Sec.trig: too many secondary trigger detected than it should be.
  • Less many Sec.trig: less secondary trigger detected than it should be.
  • Sec trig pos bad: secondary trigger detected on bad position according to sectrig validation (to disable it just set minimum to zero and maximum to 360. at Secondary trigger settings).
  • Tooth length bad: the tooth width seems to be wrong (only if Advanced filter is enabled).
  • Safe Mode: the ignition and injection are prohibited, because
    • on the ECU calibration dialog the "prohibit configuration" is bad
    • OR configured to iButton and not yet touched it
    • check these settings at ECU calibration