Subpage of Base setup menu

Ignition outputs visual

Arrow shows direction of traverse. "Real cylinder number(s)", as set here, show up in per cylinder knock and individual power gauges, to show which sparkplug, sparkplug HV-wire or cylinder acts up (without looking up output => wiring each time). "Real cylinder numbers" are for display only, do not (at the time of this writing) effect spark sequence (or engine operation in any way - you can "rotate" without any effect on firing order). The chosen ignition output (and therefore "Shift Up" / "Shift Down" buttons) effect spark sequence of course.

Number of ignition outputs can be selected. Enabling the "Dual Output Mode" is NOT recommended unless someone really knows what he is doing and sets proper dwell value (see "Ignition settings" dialog) and makes sure NOT to overload the ignition outputs/internal or external drivers, blow fuses or ignition transformers (coils). Some coils will only tolerate double frequency sparks at low RPM (might be useful in some case to get engine started first, or just for limp-home), and melt after some time at higher RPM... Active COPs are most prone to this behavior, but more rugged coils might also get damaged.
Testing mode: allows manually commanded sparks on any output (useful for testing). Beware: HIGH VOLTAGE is dangerous (potentially deadly).
Click the left bullet to show related connector pin graphically.